During the operation of the hydraulic melamine tableware molding machine, some problems will inevitably occur. The long-term downtime due to the problem may cause serious economic losses to the enterprise. For countries except China, the cost of machine maintenance will be increased a lot.

In order to meet the requirements of the continuous production of enterprises, the service life of various accessories of Shunhao Factory has been rigorously tested and continuously improved for many years.

After assembly, it will be continuously tested for more than 48 hours before being exported to foreign countries to reduce the downtime of tableware factories of foreign customers and reduce maintenance and repair costs.

In the continuous work of hydraulic crockery molding machine, it will cause the consumption of some accessories, such as oil seals, oil pumps, or other circuit appliances.

In the normal working process of the melamine hydraulic machine, there are three main reasons for the failure of the machine.

1. The Oil Seal is damaged. This situation is mainly because of the continuous running machine, which causes frequent suppression of the machine. Long-time abrasion will cause the consumption of the sealing ring. Shunhao machine uses the NOK wear-resistant oil seal from Japan which can support the machine running for a long time.

2. High pressure and low pressure are not working properly. For small mold, it is suitable for low-pressure work, so the machine pressure is appropriately adjusted less than 150 kgs, and the high-pressure pump can be free of running to protect its parts.

3. The electrical circuit system. It’s suggested to frequently check the total power supply to prevent short circuits or damage to electrical appliances caused by phase loss. All parts of SHUNHAO machines are well-known brand parts selected after years of testing.