Tel :
86-15905996312Email :
machine@hongancn.com
Tel :
86-15905996312Email :
machine@hongancn.com
Shunhao strongly advise you to protect the handle part of the Mug Mold so that it runs for a long time.
-Two iron rods need to be used correctly during the production.
-Make Sure the cavity of the mold on the top plate and the punch of the mold at the bottom.
-It is necessary to hammer the iron rod under high pressure to prevent powder scattering.
-It is recommended to alternate between two sets of hangled parts to extend their service life.
If the compresssion mug mold runs correctly, the mold will be used for many years.
No.78, Bangtai Road, Qingmeng Zone, Quanzhou, Fujian, China
Email : machine@hongancn.com
Different models of machines available and different surface or texture of molds can be made from Shunhao Factory. Rich experience since 2002 will reduce the error-cost when you running your tableware factories.
Copyright © 2024 Quanzhou Shunhao Melamine Moulds Co.,Ltd. All Rights Reserved.
Blog
ipv6 network supported
