Tel :
86-15905996312Email :
machine@hongancn.com
Reason |
Troubleshooting |
The LY4J Relay electro-oxidation
|
Replace LY4J Relay |
The switch at the eccentric wheel is in poor contact or damaged
|
Adjust or replace the micro switch |
Too much dust on the copper cover and copper frame
|
Clean by air-gun |
The timer is not set (showing 0)
|
Set baking time |
The high-voltage output copper sheet in the machine is oxidized or the copper screw is loose (current indication does not exceed 0.5A)
|
Clean the copper sheet, tighten the screw |
The diode, high-voltage transformer or electronic tube are damaged (current indication points to the right end)
|
Replace the part |
The inlet of the fan is blocked by debris, which causes insensitive of wind pressure switch
|
Clean up the debris |