Tel :
86-15905996312Email :
machine@hongancn.com
Tel :
86-15905996312Email :
machine@hongancn.com
It may cause by the following reasons, you could find out and solve the problem.
1. Wrong set of back-pressure valve; Turn to the required pressure
2. Something stuck in the back pressure valve; Just remove and clear
3. Back pressure valve damage; Change a new one
4. Auxiliary cylinder seal damaged; Change a new one
No.78, Bangtai Road, Qingmeng Zone, Quanzhou, Fujian, China
Email : machine@hongancn.com
Different models of machines available and different surface or texture of molds can be made from Shunhao Factory. Rich experience since 2002 will reduce the error-cost when you running your tableware factories.
Copyright © 2024 Quanzhou Shunhao Melamine Moulds Co.,Ltd. All Rights Reserved.
Blog
ipv6 network supported
