Tel :
86-15905996312Email :
machine@hongancn.com
Tel :
86-15905996312Email :
machine@hongancn.com
It's because one wire of 3 wires three-phase is broken or off. We can change the new wire and connect.
You could take the following steps to check and solve the problem.
1. Check whether the power is off, then switch the power on
2. Motor rotation direction wrong; Change to connect any 2 of 3 pcs of power wires
3. Hydraulic oil insufficient; Filling enough oil
4.Thermal replay tripping over motor load; Switch on the blue reset button of thermal relay
No.78, Bangtai Road, Qingmeng Zone, Quanzhou, Fujian, China
Email : machine@hongancn.com
Different models of machines available and different surface or texture of molds can be made from Shunhao Factory. Rich experience since 2002 will reduce the error-cost when you running your tableware factories.
Copyright © 2025 Quanzhou Shunhao Melamine Moulds Co.,Ltd. All Rights Reserved.
Blog
ipv6 network supported
